Traducción y análisis de palabras por inteligencia artificial
En esta página puede obtener un análisis detallado de una palabra o frase, producido utilizando la mejor tecnología de inteligencia artificial hasta la fecha:
- cómo se usa la palabra
- frecuencia de uso
- se utiliza con más frecuencia en el habla oral o escrita
- opciones de traducción
- ejemplos de uso (varias frases con traducción)
- etimología
Qué (quién) es two-jaw chuck - definición
.jpg?width=200)
![drill shanks]] of a range of diameters. The end view shows the three small jaws that slide within the body.](https://commons.wikimedia.org/wiki/Special:FilePath/ChuckDrillKeyedKeylessArbor.jpg?width=200 "drill shanks]] of a range of diameters. The end view shows the three small jaws that slide within the body.")
![faceplate]]. The jaws are stepped on one side and full height for gripping on the other and are reversible. Generally the jaws are usable for holding either outside as shown here, or inside as in gripping the inside of a pipe.](https://commons.wikimedia.org/wiki/Special:FilePath/Old4jaw.jpg?width=200 "faceplate]]. The jaws are stepped on one side and full height for gripping on the other and are reversible. Generally the jaws are usable for holding either outside as shown here, or inside as in gripping the inside of a pipe.")
Just chuck the remote control over here, willya?
![Grapevines growing on the grounds of the Bronco Wine Company in [[Ceres, California]], where Charles Shaw wine is produced.](https://commons.wikimedia.org/wiki/Special:FilePath/Bronco Winery Modesto California.JPG?width=200 "Grapevines growing on the grounds of the Bronco Wine Company in [[Ceres, California]], where Charles Shaw wine is produced.")
Wikipedia
.jpg?width=120)
A chuck is a specialized type of clamp used to hold an object with radial symmetry, especially a cylinder. In a drill, a mill and a transmission, a chuck holds the rotating tool; in a lathe, it holds the rotating workpiece.
Chucks commonly use jaws to hold the tool or workpiece. The jaws (sometimes called dogs) are typically arranged in a radially symmetrical pattern like the points of a star. Jawed chucks may require a wrench-like device called a chuck key to be tightened or loosened, but other jawed chucks may be tightened or loosened by hand force alone, offering convenience at the expense of gripping force. Chucks on some lathes have jaws that move independently, allowing them to hold irregularly shaped objects. More complex designs might include specially shaped jaws, greater numbers of jaws, or quick-release mechanisms.
Instead of jaws, a chuck may use magnetism, vacuum, or collets, which are flexible collars or sleeves that fit closely around the tool or workpiece and grip it when squeezed.
